LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2008 >> Escalade EXT >> Repair and Diagnosis >> Steering >> Steering Linkage >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Idler Arm & Relay Rod
    GM1862675Courtesy of GENERAL MOTORS CORP.
  1. Install the relay rod (5) to the vehicle.
  2. Install the pitman arm (2) to the relay rod (5).
  3. Install the idler arm (1) to the relay rod (5).
    4. NOTE: Refer to Fastener Notice .
    IMPORTANT: Use a new pitman arm nut.
  4. Install the pitman arm nut (4).

    Tighten:  Tighten the nut to 62 N.m (46 lb ft).

    5. IMPORTANT: Use a new idler arm nut.
  5. Install the idler arm nut (6).

    Tighten:  Tighten the nut to 62 N.m (46 lb ft).

  6. Install the steering linkage inner tie rods (3). Refer to Steering Linkage Inner Tie Rod Replacement .
  7. Install the steering linkage shock absorber to the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement .
  8. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  9. Adjust the front toe. Refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals