LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> Engine Performance >> System >> Data Communication System >> Diagnostic Information and Procedures >> DTC U2105-U2199 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector of the yaw rate sensor.
  2. Ignition ON, verify that a test lamp illuminates between the module voltage circuit and ground.
    • If the test lamp does not illuminate, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
  3. Ignition OFF, test for less than 5 ohms between the module ground circuits and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance. If the circuit tests normal, replace the EBCM.
  4. If all circuits test normal, replace the yaw rate sensor.
scientia non olet · About LEMON Manuals