Removal Procedure
- Remove the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
- Remove the front section of the supercharger inlet duct assembly. Refer to Supercharger Inlet Duct Assembly Replacement .
- Remove the ignition coils as an assembly. Refer to Ignition Coil Replacement - Bank 1 and Ignition Coil Replacement - Bank 2 .
- Clean the spark plug recess area with low pressure air.
- Remove the spark plugs from the cylinder heads.
- Inspect the spark plugs. Refer to Spark Plug Inspection .
WARNING:
Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.
CAUTION:
Clean the spark plug recess area before removing the spark plug. Failure to do so could result in engine damage because of dirt or foreign material entering the cylinder head, or by the contamination of the cylinder head threads. The contaminated threads may prevent the proper seating of the new plug. Use a thread chaser to clean the threads of any contamination.
CAUTION:
Allow the engine to cool before removing the spark plugs. Attempting to remove the spark plugs from a hot engine may cause the plug threads to seize, causing damage to cylinder head threads.