Installation Procedure
- Install the power steering gear (1) into the vehicle through the left wheelhouse opening.
- Install the power steering gear mounting bolts (3) and nuts (2) and tighten to 100 N.m (74 lb ft).
- Install the lower shock mounting bolts. Refer to Shock Absorber Replacement (With F55) .
- Raise the crossmember by the utility stand and remove J 33432-A .
- Install all of the crossmember mounting nuts, using hand tools only, to 110 N.m (81 lb ft).
- Install the brake pipe bracket for the left front brake caliper to the crossmember.
- Install the plastic brake pipe hold-down for the right front brake pipe.
- Install the brake BPMV bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement .
- Install the power steering pressure hose to the power steering gear and tighten the fittings to 27 N.m (20 lb ft).
- Install the power steering return hose to the power steering gear and tighten the fittings to 27 N.m (20 lb ft).
- Install the power steering hold-downs to the crossmember.
- Install the stabilizer shaft to the crossmember. Refer to Stabilizer Shaft Replacement .
- Connect the intermediate shaft to the power steering gear. Refer to Intermediate Steering Shaft Replacement .
- Connect the height sensor arm to the control arm.
- Connect the tie rod ends to the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement .
- Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Bleed the power steering system. Refer to Power Steering System Bleeding .
- Adjust the front wheel toe. Refer to Front Toe Adjustment .
CAUTION:
Refer to Fastener Caution
.