LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2010 >> Escalade EXT >> Repair and Diagnosis >> Engine Performance >> System >> Data Communication System >> Diagnostic Information and Procedures >> DTC U1826 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the Yaw and Lateral Accelerometer Sensor.
  2. Test for less than 5 Ω between the Yaw and Lateral Accelerometer Sensor ground circuit terminal 6 and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the Yaw and Lateral Accelerometer Sensor voltage (12 V reference) circuit terminal 1 and ground.
    • If the test lamp does not illuminate, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
  4. Ignition OFF, disconnect the harness connector at the EBCM
  5. Test for less than 1 Ω in each serial data circuit between the Yaw and Lateral Accelerometer Sensor and the EBCM.
    • Yaw and Lateral Accelerometer Sensor serial data circuit terminal 2 and EBCM serial data circuit terminal 33
    • Yaw and Lateral Accelerometer Sensor serial data circuit terminal 3 and EBCM serial data circuit terminal 21
    • If greater than the specified value, test the Yaw and Lateral Accelerometer Sensor serial data circuits terminals 2 and 3 for an open/high resistance.
  6. If all circuits test normal, replace the Yaw and Lateral Accelerometer Sensor.
scientia non olet · About LEMON Manuals