Removal Procedure

CAUTION:

Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.

Remove the engine shield, if equipped. Refer to Engine Shield Replacement .

Fig 1: Idler Arm, Bolts And Relay Rod

Courtesy of GENERAL MOTORS CORP.

NOTE:

Discard the idler arm nut.

Remove the idler arm nut (3) from the idler arm (1).
Separate the idler arm (1) from the relay rod (2).

Fig 2: Separating Adjustment Link From Lower Control Arm

Courtesy of GENERAL MOTORS CORP.

Remove the idler arm from the relay rod using puller J 24319-B .

Fig 3: Idler Arm, Frame Bolts And Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the idler arm bolts (3) and the nuts (1) at the vehicle frame.
Remove the idler arm (2) from the vehicle.