Front and Rear Object Alarm Module Replacement

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front & Rear Object Alarm Modules

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the left body side trim panel. Refer to Body Side Trim Panel Replacement .
1	Front And Rear Object Alarm Module Nuts (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 6 N.m (53 lb in)
2	Front And Rear Object Alarm Module Procedure Disconnect the electrical connectors. For programming and set up, refer to Control Module References

Callout

Component Name

Preliminary Procedure:
Remove the left body side trim panel. Refer to Body Side Trim Panel Replacement .

Front And Rear Object Alarm Module Nuts (Qty: 3)

CAUTION: Refer to Fastener Caution .

Tighten: 6 N.m (53 lb in)

Front And Rear Object Alarm Module

Procedure

Disconnect the electrical connectors.
For programming and set up, refer to Control Module References