LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2011 >> STS RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L - Repair Instructions >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: View Of Fuel Tank Pressure Sensor Electrical Connector
    GM1558059Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the fuel tank pressure sensor electrical connector (1).
    3. Fig 2: View Of Fuel Tank Pressure Sensor
    GM1558061Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.

  3. Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.
scientia non olet · About LEMON Manuals