LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Communication Interface Module Programming and Setup >> Communication Interface Module Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Communication Interface Module Replacement

NOTE:
  • It is critical to use the service replacement Communication Interface Module only in the vehicle for which it was ordered.
  • Failure to perform the following procedures will result in a red LED, DTC(s) being set, and limited or incomplete OnStar® services.
  • An OnStar® button press to the OnStar® call center is not required to complete the procedure.
  • It may take up to 24 hours for OnStar® service to become fully activated after performing the procedures.
  • Perform the following procedure only once. Repeat attempts of the procedure may result in a delay of the activation process.
  • To fully activate an OnStar® module, both the setup and activation request procedures must be completed on all vehicles with and without an active OnStar® subscription to insure the unit has been setup properly for the vehicle it has been installed into and also to update the OnStar® with the correct unit information.
  • To initialize the Turn-by-Turn feature, the vehicle must first be driven In open sky condition at speeds greater than 10 mph (16 kph) or more for a minimum of 5 miles (8 km), and perform at least 2 left and 2 right 90 degree turns coming to complete stops prior to each turn.
  • On vehicles up fitted with TTY capabilities, it is necessary to perform a power cycle of the OnStar® Interface Module (OTIM), and toggle the TTY mode after completing the Communication Interface Module installation and setup procedures.
  1. Install EL-49642  SPS programming support tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select ONSU Onstar® Module Setup and Service Activation and follow the on-screen instructions.
  4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  5. The default language for the new Communication Interface Module is English. To change to an alternate language, access the scan tool.
  6. Inform the customer that it may take up to 24 hours for the OnStar® service to become fully activated.
scientia non olet · About LEMON Manuals