Drive Motor Generator Control Module Sight Shield Replacement: Installation
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the sight shield onto the ball studs (2) and tighten the sight shield fastener (1).
Tighten: Tighten the fastener to 5 N.m (44 lb in).
- Install the fender brace. Refer to Front Fender Rear Upper Bracket Replacement .
- Enable high voltage. Refer to High Voltage Enabling .
IMPORTANT:
The sight shield mounting fastener must be installed and tightened. Failure to properly tighten the sight shield fastener may result in an open High Voltage Interlock Circuit (HVIC) condition and DTCs.