LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Computer Relearn Procedures) >> Engine Control Module Or Powertrain Control Module >> Service Programming System Remote Procedure (Corvette) >> PCM Programming Set Up With Special Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

PCM Programming Set Up With Special Tool

WARNING: This page does not describe the selected car, but rather 60 other vehicles, including the 2003 Saturn Vue, 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the following conditions have been met:
    • The battery is fully charged.
    • The scan tool cable connection at the Data Link Connector (DLC) is secure.
  2. Turn OFF the ignition.
  3. Remove the passenger side floor access panel. See.
  4. Remove the splice pack/star connector shorting bars from both splice pack/star connectors. It may be necessary to remove splice pack/star connectors from the mounting positions.
  5. Install the star connector cable No. 1 from the Serial Data Link Tester to the 12-pin splice pack/star connector. This is the connector with 8 or 10 wires.
  6. Install the star connector cable No. 2 from the Serial Data Link Tester to the 12-pin splice pack/star connector. This is the connector with 4 wires.
  7. Select the star connector cable No. 1 on the Serial Data Link Tester toggle switch.
  8. Select position "B" on the Serial Data Link Tester.
Fig 1: Locating & Identifying Splice Pack/Star Connectors In Passenger Floor Access Panel
G00230116Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals