Serial Data Gateway Module (SDGM) Reprogramming
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
When SDGM reprogramming must be performed, refer to Service Programming System (SPS) .
Ensure the following conditions exist in order to prepare for SDGM programming or reprogramming:
- The battery is fully charged.
- The ignition switch is in the RUN position.
- The Techline equipment cable connection at the data link connector (DLC) is secure.
Program the SDGM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user instructions.
If the SDGM fails to program, proceed as follows:
- Ensure the DLC and SDGM connections are good.
- Inspect the Techline equipment for the latest software version.
- Attempt to program the SDGM. If the SDGM still cannot be programmed properly, replace the SDGM.