LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1544 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inflatable Restraint Sensing and Diagnostic Module Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Inflatable Restraint Sensing & Diagnostic Module
GM2266671Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
WARNING: Refer to SIR Warning .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the front floor console. Refer to Front Floor Console Replacement (with RPO SLT) or Front Floor Console Replacement (without RPO SLT) .
  3. Remove the radio front floor console speaker. Refer to Radio Front Floor Console Speaker Replacement .
1 Inflatable Restraint Sensing and Diagnostic Module Nuts (Qty: 3)
CAUTION: Refer to Fastener Caution .

Tighten:  7 N.m (56 lb in)

2 Inflatable Restraint Sensing and Diagnostic Module Assembly

Procedure

  1. Position the carpet in order to access the module.
  2. Disconnect the electrical connectors.
  3. When installing, ensure the arrow on the module is pointed towards the front of the vehicle.
  4. If installing a replacement module, program the module. Refer to Control Module References .