Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the transmitter is the correct transmitter for the vehicle.
- If not the correct transmitter, replace the transmitter.
- Verify the scan tool FOB Programmed parameter for the appropriate transmitter is Yes.
- If not the specified value, program the transmitter. Refer to Remote Control Door Lock Transmitter Programming .
- Place the transmitter on the test pad of the J 43241 and press each transmitter button one at a time, holding each button for three seconds. The tester should sound a tone and illuminate a green light for the entire three second button press.
- If one or more buttons does not sound the tone and illuminate the green light for the entire three seconds, replace the transmitter battery and retest with the J 43241 . If the condition continues after battery replacement, replace the transmitter.
- Operate the transmitter while observing the scan tool Fob Function parameter for the appropriate transmitter. The parameter should correspond with the function selected on the transmitter.
- If the parameter does not match the function selected on the transmitter, replace the transmitter.
- Attempt to program the transmitter, refer to Remote Control Door Lock Transmitter Programming . The transmitter should program.
- If the transmitter does not program, test the keyless entry coax and/or antenna for a short to ground or an open/high resistance. If the circuit tests normal, replace the RCDLR.
- If all circuits test normal, replace the RCDLR.