Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the BCM (1) into the bracket. Ensure the BCM (1) is engaged in the bracket, under the retaining tabs (2).

Fig 1: Installing BCM
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connectors (2) to the BCM (1).

Fig 2: Connecting BCM Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
Install the right side knee bolster trim panel. Refer to KNEE BOLSTER REPLACEMENT - RIGHT .
If the BCM has been replaced the module will need to be programed.
Program the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration .

Fig 3: Installing Right Side Knee Bolster Trim Panel
Courtesy of GENERAL MOTORS CORP.