Steering Linkage Outer Tie Rod Replacement

Fig 1: Rack and Pinion Outer Tie Rod Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1	Steering Linkage Outer Tie Rod Nut CAUTION: Refer to Fastener Caution . Tighten 60 N.m (44 lb ft)
2	Steering Linkage Inner Tie Rod Nut Tighten 75 N.m (55 lb ft)
3	Steering Linkage Outer Tie Rod CAUTION: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint. Procedure Use the J-24319-B Puller in order to disconnect the steering linkage outer tie rod from the steering knuckle. Inspect the steering linkage inner tie rod for bent or damaged threads. Clean the tapered surface of the steering knuckle. Lubricate the steering linkage inner tie rod threads with chassis lubricant. Measure and adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment . Special Tools J-24319-B Steering Linkage and Tie Rod Puller For equivalent regional tools, refer to Special Tools .