Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful programming event, perform the following:

1. Ignition ON. Ensure the control module, DLC and programming tool connections are secure and the SPS software is up to date.
2. Reprogram the control module following the on-screen instructions.
   • If the control module cannot be reprogrammed 
   1. Ignition OFF, disconnect the MDI and exit SPS.
   2. Ignition ON, reconnect the MDI and access SPS.
   3. Reprogram the control module following the on-screen instructions.
      • If the control module cannot be reprogrammed 
      1. Ignition OFF, disconnect the MDI and exit SPS.
      2. Disconnect vehicle battery for 2 minutes. Reconnect battery.
      3. Ignition ON, reconnect the MDI and access SPS.
      4. Reprogram the control module following the on-screen instructions.
   • If the control module cannot be reprogrammed 

     Replace the K20 Engine Control Module.

   • If the control module can be reprogrammed 
3. All OK.