Front View Camera Module Scan Tool Information

Front View Camera Module Scan Tool Data Parameters

Parameter	System State	Expected Value	Description
Operating Conditions: Ignition ON/Engine OFF/Lane Departure Warning ON
System Voltage	-	Varies	The scan tool displays the system voltage depending of the current battery voltage.
System Power Mode	-	Varies	The scan tool displays Off, Accessory, Running, Cranking or Undefined. This is the state of the ignition switch.
Power Mode Controlled by Backup Device	-	Varies	The scan tool displays Off, Accessory, Running or Cranking depending of the current power mode.
Frontview Camera System Status	-	Varies	The scan tool displays Normal, Malfunction or Undefined depending on the state of the lane departure warning system.
Frontview Camera Calibration Status	-	Varies	The scan tool displays Not Calibrated, Calibrated, Dynamically Calibrated or Undefined. This is the current state of the calibration.
Frontview Camera Learn Mode Status	-	Varies %	The scan tool displays varies percentage between 0-100% depending on the state of the frontview camera learn mode.
Lane Departure Warning Status	-	Varies	The scan tool displays Off, Disabled, Not Ready to Assist, Ready to Assist, Malfunction, Unknown or Undefined depending on the state of the lane departure warning system.
Lane Departure Warning Switch Status	-	On	The scan tool displays On or Off depending on the state of the lane departure warning switch.
Lane Departure Warning Indicator Status	-	Varies	The scan tool displays Off, On, Malfunction, Unknown or Undefined depending on the state of the lane departure warning system.
Forward Collision Alert Function Status	-	Varies	The scan tool displays Off, On, Malfunction, Unknown or Undefined depending on the state of the lane departure warning system.
Intelligent Light Ranging Status	-	Varies	The scan tool displays Off, Disabled, Malfunction, Enabled, Unknown or Undefined depending on the state of the intelligent light ranging system.
Automatic High Beam Activation Status	-	Varies	The scan tool displays Disabled, Enabled or Undefined depending on the state of the automatic high beam assist system.
Following Distance Indicator Status	-	Varies	The scan tool displays Off, Disabled, Not Ready to Assist, Ready to Assist or Undefined depending on the state of the following distance indicator status.
Frontview Camera Disable History 1-4	-	Varies	The scan tool displays Empty, Lane Departure Warning Indicator Malfunction, Lane Departure Warning Switch Malfunction, Sensors Obstructed, Accelerator Pedal Position Out of Range, Driven Wheel Speed Signal Invalid, Non-Driven Wheel Speed Invalid, Brake Pedal Moderate Travel Signal Invalid, Brake Pedal Initial Travel Position Achieved, Lost Communication with Steering Wheel Angle Sensor Module, Invalid Data Received From Steering Wheel Angle Sensor Module, Forward Collision Alert Switch Malfunction, Clutch Pedal Position (CPP) Sensor Performance, Transmission Gear Engaged, Acceleration Sensor Longitudinal Signal, Invalid Data Received From Yaw Rate Sensor Module, Power Mode Controlled by Backup Device, System Power Mode, Overvoltage, Undervoltage or Undefined depending on the history data of the frontview camera disable history.

Front View Camera Module Scan Tool Output Controls

Output Control	Description
Clear Disable History Data	The frontview camera control module clears all disable history buffers when commanded from the scan tool.
Forward Collision Alert Switch	The frontview camera control module switches the forward collision alert system to Near, Medium or Far when commanded from the scan tool.
High Beams	The frontview camera control module switches the high beams On or Off when commanded from the scan tool.
Lane Departure Warning Indicator	The frontview camera control module switches the lane departure warning indicator On or Off when commanded from the scan tool.
Lane Departure Warning Switch	The frontview camera control module switches the lane departure warning system On or Off when commanded from the scan tool.
Vehicle Direction Camera Learn	The frontview camera control module initializes the service point calibration of the frontview camera and switches into the learn mode when commanded from the scan tool.