Adding Transmitters (Without SPS)
NOTE:
- To initiate, this procedure requires that 1 learned transmitter be available.
- A total of eight transmitters can be learned to a single vehicle.
- This procedure adds transmitters only. The procedure does not erase previously learned transmitters.
- Place the recognized transmitter(s) in the vehicle cupholder.
- Insert the mechanical key of the new transmitter into the key lock cylinder located on the outside of the driver door and turn the key to the unlock position five times within ten seconds. The Driver Information Center (DIC) will display Ready For Remote #2, 3, 4 or 5.
- Place the new transmitter into the transmitter pocket.
- Press and release the ignition mode switch. When the transmitter is learned, the DIC will indicate that it is ready to program the next transmitter.
- Remove the transmitter from the transmitter pocket and press the transmitter unlock button. To program additional transmitters, repeat Steps 3 through 5.
- When all additional transmitters are programmed, press and hold the ignition mode switch for 15 seconds to exit programming mode.
NOTE:
The transmitter pocket is located inside the center console storage area, near the front of the storage compartment. The transmitter must be inserted vertically into the pocket with the buttons facing toward the front of the vehicle. If a large keyring prevents the transmitter from being fully inserted into the pocket, remove the keyring and insert the transmitter in the pocket. Failure to fully insert the transmitter into the pocket will result in an inability to program.