Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing control module, perform the following procedure:

1. Install EL-49642  SPS Programming Support Tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K40P Seat Memory Control Module - Passenger - Programming and follow the on-screen instructions.
4. At the end of programming, choose the Clear All DTCs function on the SPS screen.
5. Move the seat to a central, middle range position, then perform the memory store operation for memory "1", "2" and "Exit" or "3" if equipped. Refer to the Owner Manual for storing memory seat positions.