Programming an Existing or New Control Module

To program an existing or new control module, perform the following procedure:

1. Install the special tool: EL-49642  SPS Programming Support Tool
2. Ignition» On / Vehicle» In Service Mode
3. Access SPS and follow the on-screen instructions for the control module: K71 Transmission Control Module - Programming
4. After the programming is complete, select: Setup - If available

   If Setup is not available in SPS - Perform the appropriate learn/reset procedure with the scan tool

5. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.