Removal Procedure
WARNING:
CAUTION:
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Place the ignition switch in the OFF position.
- Without draining the engine coolant and without disconnecting the hoses, remove and position aside the radiator surge tank. Radiator Surge Tank Replacement (LGX With V08)Radiator Surge Tank Replacement (LGX without V08)
- Remove Brake Pressure Modulator Valve Master Cylinder Reservoir Front Pipe Brake Pressure Modulator Valve Master Cylinder Reservoir Front Pipe Replacement
- Remove Brake Pressure Modulator Valve Master Cylinder Reservoir Rear Pipe Brake Pressure Modulator Valve Master Cylinder Reservoir Rear Pipe Replacement
- Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
- Disconnect the EBCM electrical connector.
- Disconnect Left Front Brake Pipe Fitting (1)
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
- Disconnect Right Front Brake Pipe Fitting (1)
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
- Disconnect Right Rear Brake Pipe Fitting (1)
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
- Disconnect Left Rear Brake Pipe Fitting (1)
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
- Remove Brake Pressure Modulator Valve Bracket Bolt (1)
- Remove Electronic Brake Control Module with Brake Pressure Modulator Valve Assembly (1)
- Remove Electronic Brake and Traction Control Module Bracket Electronic Brake and Traction Control Module Bracket Replacement