Programming an Existing or New Control Module

To program an existing or new control module, perform the following procedure:

1. Install the special tool: EL-49642 SPS Programming Support Tool
2. Ignition - On / Vehicle - In Service Mode
3. Access SPS and follow the on-screen instructions For the control module: K69 Transfer Case Control Module
4. perform the SPS function: K69 Transfer Case Control Module - Programming
5. perform the SPS function: K69 Transfer Case Control Module - Setup
6. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.