Programming a New Control Module

To program a new control module, perform the following procedure:

CAUTION:

DO NOT program the K114B Hybrid/EV Powertrain Control Module 2 with the drive Motor battery charger cable connected to the vehicle. Charging while programming may result in damage to the High Voltage Battery Disconnect Relays.

1. Install the special tool: EL-49642 SPS Programming Support Tool
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K114B Hybrid/EV Powertrain Control Module 2 - Programming and follow the on-screen instructions.
4. At the end of programming, choose the "Clear All DTCs".
5. With a scan tool, perform the Hybrid/EV Battery Pack Capacity Learn and follow the on-screen instructions.
6. With a scan tool, select the Passenger Compartment Heater Coolant Control Solenoid Valve Learn Procedure and follow the on-screen instructions.
7. With a scan tool, perform the Clear Secured High Voltage DTCs and follow the on-screen instructions.
8. With a scan tool, Clear All DTCs.
9. With a scan tool, select Hybrid/EV Battery Pack Charging Adaptive Learn Reset in the K114B Hybrid/EV Powertrain Control Module 2 Reset Functions menu and follow the on-screen instructions.