Programming a New Control Module

To program a new control module, perform the following procedure:

1. Install the special tool:EL-49642 SPS Programming Support Tool
2. Ignition - On / Vehicle - In Service Mode
3. Access SPS and follow the on-screen instructions for the control module:K47 Rear Differential Clutch Control Module
4. Perform the SPS function:Prepare Control Module for Removal
5. Perform the SPS function:Programming
6. Perform the SPS function:Setup
7. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
8. Perform the configuration/reset function:Rear Differential Clutch Control Module Calibration