Steering Gear Boot Replacement (NJ2)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Steering Linkage Outer Tie Rod Replacement If servicing the right side steering gear boot, remove the steering gear heat shield. Steering Gear Heat Shield Replacement (NJ2)
1	Steering Linkage Inner Tie Rod Nut Procedure Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod.
2	Steering Gear Boot Outer Clamp
3	Steering Gear Boot Inner Clamp Procedure Cut the steering gear boot inner clamp. DISCARD the clamp. Use the CH-22610 pliers to install the NEW steering gear boot inner clamp. Special Tools CH-22610 Pliers Equivalent regional tools:Special Tools
4	Steering Gear Boot Procedure After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination.If corrosion or contamination is evident, replace the steering gear. Electric Belt Drive Rack and Pinion Steering Gear Replacement (FWD, LFX, NJ2) Install the steering gear boot and ensure the boot is seated in the assembly groove of the steering gear before installing the steering gear boot clamps.
5	Steering Gear Boot Inner Seal Procedure Apply a small amount of Lithium Grease or equivalent to the inside of both ends of the steering gear boot. Adhesives, Fluids, Lubricants, and Sealers