Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Steering Knuckle Nut at Strut Assembly (GNA) | |
| First Pass: | 85 N.m (63 lb ft) |
| Final Pass: | 65 degrees |
| Steering Knuckle Bolt - GNA | |
| Steering Knuckle Upper Camber Adjust Bolt - GNB | |
| Steering Knuckle Lower Camber Adjust Bolt - GNB | |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Steering Knuckle Upper Camber Adjust Nut - GNB | |
| First Pass: | 100 N.m (74 lb ft) |
| Final Pass: | 45 - 60 degrees |
| Steering Knuckle Lower Camber Adjust Nut - GNB | |
| First Pass: | 100 N.m (74 lb ft) |
| Final Pass: | 45 - 60 degrees |
| Rear Axle Upper Control Arm Inner Nut (GNE) | 150 N.m (111 lb ft) |
| Rear Suspension Toe Adjust Link Inner Nut (GNE) | 150 N.m (111 lb ft) |
| Steering Linkage Outer Tie Rod Nut | 60 N.m (44 lb ft) |