Unsuccessful Programming Recovery

If programming a control module is not successful, perform the following procedure:

1. Verify the control module, data link connector and programming tool connections are secure and the tool software is up to date.
2. Ignition - On/Vehicle - In Service Mode
3. Access SPS and follow the on-screen instructions for the control module: K71 Transmission Control Module - Programming

   Verify the control module programming is successful.

   • If the programming is not successful 
   1. Ignition/Vehicle - Off - For greater than 2 min
   2. Ignition - On/Vehicle - In Service Mode
   3. Perform the SPS function: K71 Transmission Control Module - Programming
      • If the programming is not successful - Replace the component: K71 Transmission Control Module
      • Go to next step: If the programming is successful
   4. Select - MCVM Operations - If applicable
   5. Ignition/Vehicle - Off - For greater than 2 min
   6. Select - Setup - Follow the on-screen instructions.

      If setup is not an available option - Perform the appropriate learn/reset procedure with the scan tool

   7. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
   8. All OK.
   • Go to next step: If the programming is successful 
4. Select - MCVM Operations - If applicable
5. Ignition/Vehicle - Off - For greater than 2 min
6. Select - Setup - Follow the on-screen instructions.

   If setup is not an available option - Perform the appropriate learn/reset procedure with the scan tool

7. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
8. All OK.