Replace and Program ECU or Reprogram ECU

To program a replacement or an existing ECU, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K83 Park Brake Control Module - Programming and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K83 Park Brake Control Module - Setup (OR K83 Park Brake Control Module - Configuration and Setup) and follow the on-screen instructions.
4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
5. With a scan tool, perform the Parking Brake Cable Adjuster Enabling procedure. Refer to Parking Brake Cable Adjuster Enabling .