Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Off-Board Charger Control Module (1) - Install
Connect the electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

{If equipped} Connect the electrical connector.
Starting at the front of the front side door sill garnish molding (1) engage the retaining clip on the forward vertical wall.
Work your way rearward engaging the front side door sill garnish molding retaining clips.
Front Side Door Sill Garnish Molding - Right Side (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Hood Primary and Secondary Latch Release Handle (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Install the right side instrument panel lower trim panel insulator (1) to the floor studs.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Connect the instrument panel wiring harness (3) to the instrument panel lower trim panel insulator.

CAUTION:

Instrument Panel Lower Trim Panel Insulator Bolt (2) - Install and tighten - Fastener Specifications
{If equipped} Instrument Panel Insulator Nut (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

WARNING:
When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.

NOTE:
Left side shown, right side similar.

Instrument Panel Knee Bolster (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Instrument Panel Knee Bolster Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Insert the tab at the top of the instrument panel outer trim cover (1) into the instrument panel before installing.