Engagement Switch

Disconnect switch harness three wire connector at lower part of steering column.
NOTE: Wire colors are the same in all models except where noted.

Connect an ohmmeter between terminal number 1 (brown wire) and terminal number 2 (blue wire). Continuity should be maintained until switch is pressed all the way in.
Connect ohmmeter between terminal number 1 (brown wire) and terminal number 3 (black wire). No continuity should be shown. With button partially depressed, ohmmeter should show continuity. With button fully depressed, ohmmeter should again show no continuity.
Connect ohmmeter between terminal number 2 (blue wire) and terminal number 3 (black wire). No continuity should be shown. With button partially and then fully depressed, continuity should be shown.