Removal & Installation
WARNING: This page is about the Monte Carlo Base, 3.8 9, which is a different variant/trim than selected.
TRANS ID - 200, 200C, 200-4R
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| w/o Overdrive | | 3.2 | 2.4 | C |
| w/Overdrive | | 3.5 | 2.6 | C |
| Combination Procedure: CONVERTER: Drain & Test: |
| | 0.2 | 0.2 | C |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| | 0.2 | 0.2 | C |
| Combination Procedure: FRONT PUMP (REMOVED): Overhaul: |
| | 0.5 | 0.5 | B |
| Combination Procedure: FRONT PUMP BUSHING & SEAL: Remove & Replace: |
| | 0.3 | | B |
| Combination Procedure: OIL PUMP: Remove & Replace: |
| Front | | 0.6 | 0.6 | B |
| Combination Procedure: OIL PUMP SEAL: Remove & Replace: |
| Front | | 0.2 | | B |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| | 0.1 | | C |
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: |
| | 0.6 | 0.3 | C |
TRANS ID - 250, 250C, 350, 350C
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| | 2.8 | 2.1 | C |
| Combination Procedure: CONVERTER: Drain & Test: |
| | 0.2 | | C |
| Combination Procedure: EXTENSION HOUSING: Remove & Replace: |
| | 0.2 | | B |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| | 0.3 | | C |
| Combination Procedure: FRONT PUMP (REMOVED): Overhaul: |
| Trans Mfr CD 250C/M31 | | 0.5 | | B |
| Combination Procedure: FRONT PUMP BUSHING & SEAL: Remove & Replace: |
| | 0.3 | | B |
| Combination Procedure: INTERMEDIATE CLUTCH ACCUMULATOR: Remove & Install or Overhaul: |
| | 0.2 | | A |
| Combination Procedure: OIL PUMP: Remove & Replace: |
| Front | | 0.5 | | B |
| Combination Procedure: OIL PUMP SEAL: Remove & Replace: |
| Front | | 0.2 | | B |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| | 0.1 | | C |
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: |
| | 0.6 | | C |