EGR System
- Connect a tachometer to engine. Disconnect vacuum hose 3-way connector to canister, and connect a vacuum gauge to 3-way connector between EGR valve and TVV. When engine is cold, start engine and check that vacuum gauge indicates no vacuum at any speed.
- Warm up engine and check that vacuum gauge indicates no vacuum at idle and over 2 in. Hg at 3500 RPM. Disconnect vacuum hose to EGR valve and plug hose. Check that engine speed increases a little. Stop engine and push diaphragm plate by hand and release it. Check that diaphragm plate returns smoothly to original position.CAUTION: If valve is hot it may be necessary to wear gloves to avoid burning fingers.
- If a problem is found, inspect each part. Disconnect vacuum gauge and connect vacuum hose 3-way to canister.