Code 24 (VSS)
- Verify speedometer operation. Disconnect speedometer cable at transaxle. Turn ignition on and check voltage at ECM harness connector A10 and ground while turning speedometer cable slowly.
- If voltage varies from 1-6 volts, problem is intermittent. If voltage is 8-12 volts and steady, check VSS harness for open or short. If harness is good, replace VSS.
- If voltage is below one volt, disconnect harness at VSS and check voltage. With ignition on, if voltage is above 10 volts, replace VSS.
- If voltage is below 10 volts, check VSS harness to ECM connector A10 for shorting to ground. If harness tests good, repair harness connector or replace ECM.