September 30: LEMON manuals is back up on a temporary server! Slowness is possible
WASTEGATE/Boost Pressure Test
- Inspect wastegate and actuator assembly for linkage damage. Check condition of hose from throttle body to wastegate solenoid and from wastegate solenoid to actuator. Remove hose.
- Connect a hand-held Vacuum/Pressure Pump (J-23738) in series with component Gauge (J-28474) to actuator assembly hose.
- With 4 psi (.28 kg/cm2
) pressure applied, actuator should move rod .015" (.38 mm). Replace actuator if not operating properly. Check new unit and crimp threads on rod to maintain proper calibration. Remove test equipment. Reconnect actuator-to-wastegate solenoid hose.