LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1992 >> APV >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Fuel System (Diesel) >> Inhibit Switch (Black Cap)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inhibit Switch (Black Cap)

  1. Remove connector from inhibit switch when engine temperature is less than 100°F (38°C). Inhibit switch is located in water crossover near front of engine. Set ohmmeter on low range. Test continuity across switch terminals. Switch should be closed (a reading of less than 1.0 ohm on meter.)
  2. Test terminals for continuity to ground with a test light or ohmmeter on high scale. Light should be off. Meter should show greater than 1.0 megohm. Replace switch if results are not as specified.
  3. Disconnect plug from switch terminals when engine temperature is greater than 125°F (52°C). Change ohmmeter setting to highest scale or use a self-powered test light. Test continuity across switch terminals. Test continuity from each terminal to ground. Switch should be open (test light off or high ohm reading of greater than 1.0 megohm on meter). Replace switch if it is closed. When installing replacement switch, tighten to 17 ft. lbs. (23 N.m).
scientia non olet · About LEMON Manuals