LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1998 >> Corvette 2D Convertible, Automatic >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Module >> BCM Programming/RPO Configuration >> Body Control Module >> Programming Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming Procedure

  1. Using scan tool, select NEW BCM SETUP. Program BCM with correct RPO code configuration. Go to next step.
  2. Using scan tool, check for proper communication between BCM and PCM. If components cannot communicate, diagnose and repair problem as necessary. If BCM and PCM are communicating properly, go to next step.
  3. Turn ignition on (engine off) for 11 minutes. Turn ignition off for 30 seconds. Turn ignition on (engine off) for 11 minutes. Turn ignition off for 30 seconds. Turn ignition on (engine off) for 11 minutes or until DTC P1630 sets. Turn ignition off for 30 seconds. Turn ignition on (engine off) for 30 seconds. Attempt to start engine. If engine starts and runs normally, go to next step. If engine does not start and run normally, go to step 5).
  4. Using scan tool, check for DTCs. Clear PCM DTCs. Turn ignition off for 30 seconds. Attempt to start engine. If engine starts and runs normally, programming procedure is complete. If engine does not start and run normally, go to next step.
  5. If DTC P1626, P1630 or P1631 is set, see TESTS W/CODES article in ENGINE PERFORMANCE section. If DTC P1626, P1630 or P1631 is not set, go to step 2).
scientia non olet · About LEMON Manuals