LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1998 >> Forward Control P12 >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Computer Relearn Procedures) >> Computer Relearn Procedures - Cars >> SATURN >> Crankshaft Learn Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Learn Procedure

WARNING: This page does not describe the selected car, but rather 69 other vehicles, including the 1999 Saturn SW2, 1999 Saturn SW1, 1999 Saturn SL2, 1999 Saturn SL1, and 1999 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.
  1. The PCM uses crankshaft velocity calculations to determine engine misfire and to operate engine misfire self-diagnostics. PCM must know precisely the variation between notches on the crankshaft. PCM contains crankshaft learn procedure which learns the variation between notches on crankshaft. The crankshaft learn procedure must be reset if PCM, crankshaft, or crankshaft position sensor are replaced.
  2. If crankshaft learn procedure is being performed as a result of replacing the crankshaft, reset crankshaft learn procedure using Service Stall System (SSS) equipment and manufacturer's instructions. If replacing PCM with a replacement PCM, procedure will be prompted automatically. Allow engine to idle until SERVICE light flashes. Hold engine speed between 3000-4000 RPM until light goes off after about 10-20 seconds.
NOTE: If any Diagnostic Trouble Codes (DTCs) exist that relate to an engine misfire, crankshaft learn procedure will not be initiated. Any DTCs for engine misfire must be corrected before performing crankshaft learn procedure.
scientia non olet · About LEMON Manuals