Engine Controls - Tests W/Codes - 1.0L: Introduction

Most engine control problems are the result of mechanical breakdowns, poor electrical connections or damaged vacuum hoses. Before considering the computer system as a possible cause of problems, perform checks and inspections covered in BASIC TESTING - 1.0L article. Failure to do so may result in lost diagnostic time.

If no faults were found while performing BASIC TESTING - 1.0L proceed with SELF-DIAGNOSTIC PROCEDURES. If no fault codes are present and driveability problems exist, proceed to TESTS W/O CODES - 1.0L article for diagnosis by symptom (i.e., ROUGH IDLE, NO START, etc.). If only intermittent codes are present, see INTERMITTENTS in TESTS W/O CODES - 1.0L article.