Scan Tool Data
NOTE:
Information contained in the following tables is typical of readings taken on a vehicle with engine idling at normal operating temperature, throttle closed, transmission in Park or Neutral, system in closed loop status, and all accessories off (except as noted in tables). For additional information, see scan tool owner's manual.
SCAN TOOL DATA VALUES
| Scan Tool Parameters |
Typical Data Value |
| A/C Switch |
Off |
| Base Injector PWM Cylinder No. 1 |
2.2-4.8 mS |
| Command A/C |
Off |
| Decel Fuel Mode |
Inactive |
| Diagnostic Mode |
Normal |
| ECT |
176-194°F (80-90°C) |
| Electrical Load |
No |
| Engine Load |
19.7-49.3% |
| Engine Speed |
650-750 RPM |
| Engine Speed At Misfire |
Zero |
| Fuel Trim (Long Term) |
-20-+20% |
| Fuel Trim (Short Term) |
-20-+20% |
| HO2S-1 |
Varies |
| HO2S-1 Lean/Rich Response Time |
0-1000 mS |
| HO2S-1 Rich/Lean Response Time |
0-1000 mS |
| HO2S-2 |
Varies |
| IAC Duty Cycle |
27-47% |
| IAT |
68-95°F (20-35°C) |
| IGN. Cycle Counter |
0-2000 |
| Load At Misfire |
0.00 G/Rev |
| Loop Status |
Closed |
| MAP (Pressure) |
4.2-6.8 psi (29-47 kPa) |
| MAP (Voltage) |
1.32-1.90 volts |
| MIL Requested By DTC |
No |
| Misfire Current Cyl #1 |
Zero |
| Misfire Current Cyl #2 |
Zero |
| Misfire Current Cyl #3 |
Zero |
| Misfire Current Cyl #4 |
Zero |
| Park Neutral Position (PNP) Switch |
Park Or Neutral |
| Powertrain DTC |
Zero |
| Spark |
8-18° |
| Starter Switch |
Released |
| TCC Brake Switch |
Released |
| TCC Solenoid |
Off |
| Total Fuel Trim |
Varies |
| Total Misfire Current Count |
Zero |
| TP Sensor |
11% |
| Vehicle Speed |
Zero MPH (Zero km/h) |