Engine Assembly: Remove, Install, and Overhaul

Includes: Replace Rings, Main and Rod Bearings, Camshaft(s), Crankshaft and Timing Components. Remove Cylinder ridge, burnish Cylinders, grind Valves and clean and test or replace Lifters. Includes (where applicable): Adjust Valves. DOES NOT include Pin fit or rebore and align Rods. See machine operations.

Applies To	Note	Standard Hours	Warranty Hours	Skill Level
4WD,Automatic Trans		29.6		A
Additional Procedure: ENGINE ASSEMBLY: Remove, Install, and Overhaul:
w/Skid Plate add		0.3		A
Where Air Cond interferes add		0.3		A
Where Cruise Control interferes add		0.2		A
Where Eng Oil Cooler interferes add		0.4		A
Where Pwr Stg interferes add		0.4		A
Where Trans Oil Cooler interferes add		0.2		A
Combination Procedure: CAMSHAFT BEARING: Remove & Replace: NOTE: This operation applies to full circle, resistance fit bearings only. For split cap type bearings use Camshaft - R&R.
Each		0.3		A
Combination Procedure: OIL PUMP: Overhaul:
		0.6		B
Combination Procedure: VALVE GUIDE: Remove & Replace:
Each		0.2		A