New BCM Setup

NOTE: Following procedure is written specifically for Tech 2 scan tool. A generic scan tool may not be capable of performing all necessary reprogramming functions.

NOTE: After programming new BCM, go to THEFT DETERRENT RELEARN .

NOTE: After BCM setup, BCM personalization settings default to a default setting and personalization settings will need to be set as needed.

Connect scan tool to Data Link Connector (DLC). Turn ignition switch to RUN position. Select DIAGNOSTICS and input all required vehicle data as prompted by scan tool. Select BODY CONTROL MODULE. When MAIN MENU is displayed, select SPECIAL FUNCTIONS. Select new VIN and input all required data. Exit back into SPECIAL FUNCTIONS menu. Select BCM REPROGRAMMING. Select SETUP BCM. Scan tool will display NOW SETTING UP THE NEW BODY CONTROL MODULE. When BCM has been successfully setup, scan tool will display BODY CONTROL MODULE SETUP IS COMPLETE. Exist back into SPECIAL FUNCTIONS. Select SET OPTIONS. Select POINT OF SALE. Input all required data as prompted. Exit back into SET OPTIONS menu. Select OPTION CONFIGURATION. Input all required data as prompted.
After completing new BCM setup procedure, perform THEFT DETERRENT RELEARN procedure. If theft deterrent relearn procedure is not performed, vehicle will not be protected against theft by Passlock(tm) system and engine will not start.