Scan Tool Display

The following are Tech 1 or Tech 2 scan tool sub-menus in the DTC INFO and SPECIFIC DTC modes:

• DTC INFO MODE
  
  Used to search for specific type of stored DTC information. There are 7 choices in this mode. Technician may be instructed to test DTCs in a certain manner. Follow the affected DTC test procedures. To get complete description of any status, hit ENTER key before pressing the desired "F" key.
• DTC STATUS
  
  This selection will display any DTCs that have not run during the current ignition cycle or have reported a test failure during this ignition up to a maximum of 33 DTCs. A DTC test that runs and passes will cause affected DTC to be removed from scan tool screen.
• FAIL THIS IGN.
  
  This selection will display all DTCs that have failed during the present ignition cycle.
• HISTORY
  
  This selection will display only DTCs that are stored in the control module's history memory. It will not display type "D" DTCs. It will display all type "A" and type "B" DTCs that have the MIL illuminated and have failed within the last 40 warm-up cycles. It will also display type "C" DTCs that have failed within the 40 warm-up cycles.
• LAST TEST FAIL
  
  This selection will only display DTCs that have failed the last time the test ran. If type "A" or "B" DTCs are displayed, the last test may have ran during the previous ignition cycle. For type "C" DTCs, the last failure must have occurred during the current ignition cycle to be displayed as LAST TEST FAIL.
• MIL REQUEST
  
  This selection will only display DTCs that are requesting MIL illumination. Type "C" DTCs cannot be displayed using this option. This selection will report type "B" DTCs only after MIL illumination has been requested.
• NOT RUN SCC
  
  Not Run Since Code Clear option will display up to 33 DTCs that have not run since DTCs were last cleared. Since any displayed DTCs have not run, their condition (passing or failing) is unknown.
• TEST FAIL SCC
  
  Test Fail Since Code Clear selection will display all active and history DTCs that have reported a test failure since the last time DTCs were cleared. DTCs that last failed over 40 warm-up cycles before this option is selected will not be displayed.
• FAILED SINCE CLEAR
  
  This message indicates the DTC has failed at least once within the last 40 warm-up cycles since the last time DTCs were cleared.
• NOT RUN SINCE CL.
  
  Not Run Since Cleared message indicates that the selected diagnostic test has not run since the last time DTCs were cleared. Therefore, the diagnostic test status (passed or failed) is unknown. After DTCs are cleared, this message will continue to be displayed until the diagnostic test runs.
• NOT RUN THIS IGN.
  
  Not Run This Ignition message indicates the selected diagnostic test has not run this ignition cycle.
• TEST RAN AND PASSED
  
  This message indicates the selected diagnostic test has:
  • Passed the last test.
  • Ran and passed during this ignition cycle.
  • Ran and passed since DTCs were last cleared.
  • Test has not failed since DTCs were last cleared.

  If this message is displayed, repair is complete. If FAILED THIS IGN. message is displayed, repair is incomplete and further diagnosis is required.