LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2001 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Body Control Modules) >> Removal & Installation >> Instrument Panel Integration Module (IPM) >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove fasteners securing closeout insulator panel (3) to instrument panel retainer. Remove push-in retainer to release closeout insulator panel from IP retainer. Turn heater temperature sensor (2) 1/4 turn counterclockwise to remove sensor from closeout insulator panel (3). Disconnect electrical connector (1) from lower IP courtesy light. See Figure. Slide closeout insulator panel rearward to remove from vehicle.
  2. Remove screw retaining IPM to underside of instrument panel carrier. Rotate IPM up and out of instrument panel retainer. Disconnect harness connector.
  3. To install, reverse removal procedure. Tighten IPM retaining fastener to 18 INCH Lbs. (2 N.m). Program IPM. SeeINSTRUMENT PANEL INTEGRATION MODULE  under PROGRAMMING.
scientia non olet · About LEMON Manuals