LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Repair Instructions >> Electronic Brake Control Module (EBCM) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the EBCM to the BPMV.
  2. Install the four retainers that attach the EBCM to BPMV. Tighten the retainers to 5 N.m (44 lb in).
  3. Connect the EBCM harness connector.
  4. Push down lock tab (1) and then move sliding connector cover (2) back in the home position to lock.
  5. Reengage the red locking tab (1) to the connected lock tab.
  6. Install the air cleaner intake duct.
  7. Reposition the module and cables. Connect the cruise control module to the left strut tower.
  8. Connect the accelerator and cruise control cable to the accelerator control cable bracket.
  9. Install the front fender upper diagonal brace.
  10. Install the fuel injector sight shield, 3.8 L engine only.
  11. Turn the ignition switch to the RUN position, do not start engine.
  12. Perform the Diagnostic System Check - ABS .
scientia non olet · About LEMON Manuals