LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Self-Diagnostics - 3.8L >> Programming >> Theft Deterrent System Components >> Impala, Monte Carlo & Regal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Impala, Monte Carlo & Regal

NOTE: The Body Control Module (BCM) must be programmed with the proper RPO configurations before performing learn procedures. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.

If replacing the BCM with a GM Service Parts Operations (SPO) replacement part, the module will learn Passlock™ sensor data code immediately. The existing PCM however, must learn the new fuel continue password when the BCM is replaced.

If replacing a PCM with a GM Service Parts Operations (SPO) replacement part, after programming, these modules will learn the incoming fuel continue password immediately upon receipt of a password message. Once a password message is received, and a password is learned, a learn procedure must be performed to change this password again. A PCM which has been previously installed in another vehicle will have learned the other vehicle's fuel continue password and will require a learn procedure after programming to learn the current vehicle's password.

10 Minute Learn Procedure

  1. Connect the Tech 2 to the vehicle.
  2. Select REQUEST INFORMATION under SERVICE PROGRAMMING.
  3. Disconnect the Tech 2 from the vehicle and connect it to a techline terminal.
  4. On the techline terminal, select THEFT MODULE RE-LEARN under SERVICE PROGRAMMING.
  5. Disconnect the Tech 2 from the techline terminal and connect it to the vehicle.
  6. Turn on the ignition, with the engine off.
  7. Select VTD RE-LEARN under SERVICE PROGRAMMING.
  8. Attempt to start the engine, then release the key to on (vehicle will not start).
  9. Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn off (the vehicle is now ready to relearn the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from off to crank).
  10. Turn off the ignition, and wait 5 seconds.
  11. Start the engine (the vehicle has now learned the password).
  12. With the scan tool, clear any DTCs.

30 Minute Learn Procedure

  1. Turn on the ignition, with the engine off.
  2. Attempt to start the engine, then release the key to on (vehicle will not start).
  3. Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn off.
  4. Turn off the ignition, and wait 5 seconds.
  5. Repeat procedure 2 more times for a total of 3 cycles/30 minutes (the vehicle is now ready to relearn the Passlock™ Sensor Data Code and/or passwords on the next ignition switch transition from off to crank).
    6. NOTE: The vehicle learns the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from off to crank. You must turn the ignition off before attempting to start the vehicle.
  6. Start the engine (the vehicle has now learned the Passlock™ Sensor Data Code and/or password).
  7. With a scan tool, clear any DTCs if needed (history DTCs will self clear after 100 ignition cycles).
scientia non olet · About LEMON Manuals