LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Self-Diagnostics - 2.0L >> Inspection/Maintenance Procedures >> Inspection/Maintenance Catalyst System Set Procedure >> Diagnostic Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedures

  1. Did you perform the Inspection/Maintenance (I/M) System Check? If yes, go to next step. If no, go to INSPECTION/MAINTENANCE SYSTEM CHECK  .
    2. WARNING: Road test vehicle under safe conditions and while obeying all traffic laws. Do not attempt any maneuvers that could jeopardize vehicle control. Failure to adhere to these precautions could lead to serious personal injury and vehicle damage.
  2. Ensure the vehicle is within the Conditions for Running. See CONDITIONS FOR RUNNING  . Turn OFF all of the accessories, e.g., A/C, blower fan, etc. Start and idle the engine. Important: In order for this test to run, the vehicle must operate in the following conditions: Idle engine at the operating temperature for 1 minute. Accelerate at part throttle to 45-65 MPH (72-105 km/h). Maintain this speed without changing the throttle position for 2-3 minutes or until the I/M System Status updates to YES. Using scan tool, observe the I/M System Status display. Did the Catalyst System Status update to YES? If yes, go to step  5 . If no, go to next step.
  3. Using scan tool, observe DTC Information. Does the scan tool indicate any failed DTCs? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  . If no, go to next step.
    NOTE: Refer to INSPECTION/MAINTENANCE SYSTEM DTC TABLE  to determine which DTCs are required to run in order to complete this test.
  4. Using scan tool, observe the NOT RAN SINCE CODE CLEARED display. Determine which of the DTCs required for a YES status has not run. Enter DTC in Specific DTC menu on scan tool. Operate vehicle within Conditions for Running DTC. Repeat procedure until scan tool indicates the diagnostic test has run. Repeat this step for any additional required DTCs that have not run. Using scan tool, observe I/M System Status display. If yes, go next step. If no, see DIAGNOSTIC AIDS  .
  5. Using scan tool, observe emission related DTC portion of I/M System Status display. Does scan tool indicate any emission related DTCs? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  . If no, system is okay.
scientia non olet · About LEMON Manuals