LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> SSR LS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 5.3L - Introduction >> Repair Instructions >> Fuel Sender Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Fuel Sender Assembly
    GM386369Courtesy of GENERAL MOTORS CORP.
    CAUTION: In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket when reinstalling the fuel sender assembly.
    IMPORTANT: The fuel pump strainer must be in a horizontal position when the fuel sender is installed in the tank. When installing the fuel sender assembly, assure that the fuel pump strainer does not block full travel of the float arm.
  1. Install the new seal on the fuel tank.
  2. Install the fuel sender assembly into the fuel tank.
  3. Install the fuel sender assembly retaining ring using the J 44402  .Special Tools .
  4. Install fuel lines to sender assembly. Refer to Fuel Hose/Pipes Assembly Replacement .
  5. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals