Installation Procedure

Fig 1: View Of Fuel Tank & Sender

Courtesy of GENERAL MOTORS CORP.

Install the fuel level sensor to the fuel sender assembly. Refer to Fuel Level Sensor Replacement
Install the new seal on the fuel tank (4).
Align the fuel pipes parallel with the mark on the fuel tank.
Slowly apply pressure to the top of the spring loaded sender until the sender aligns flush with the retainer on tank.

IMPORTANT: Be sure that the retaining ring is fully seated within the tab slots.

Install the retaining ring (1) using the J 39765 . See Special Tools and Equipment .
Connect the wiring harness to the fuel sender and the FTP sensor.
Install the fuel tank. Refer to Fuel Tank Replacement .