LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala Base, 3.4 E >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System 3.4L (Introduction) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the accelerator pedal (1) to the cowl (4).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the accelerator pedal bolt (3) and the stud (2).

    Tighten:  Tighten the bolt and the stud to 5 N.m (44 lb in).

  3. Install the accelerator cable (5) to the accelerator pedal (1).
  4. Inspect for complete throttle opening and closing positions by operating the accelerator pedal. The throttle should operate freely and without binding between full-closed and wide-open throttle. Inspect for proper carpet fit under the accelerator pedal.
  5. Install the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
    6. Fig 1: Accelerator Pedal & Components
    GM12287Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals